--- kernel-2.6.27.orig/sound/arm/Kconfig
+++ kernel-2.6.27/sound/arm/Kconfig
@@ -41,5 +41,68 @@
 	  Say Y or M if you want to support any AC97 codec attached to
 	  the PXA2xx AC97 interface.
 
-endif	# SND_ARM
+config SND_OMAP_AIC23
+	tristate "OMAP AIC23 alsa driver (osk5912)"
+	depends on ARCH_OMAP && SND
+	select SND_PCM
+	select I2C
+	select I2C_OMAP if ARCH_OMAP
+	select SENSORS_TLV320AIC23
+	help
+	  Say Y here if you have a OSK platform board
+	  and want to use its AIC23 audio chip.
+
+	  To compile this driver as a module, choose M here: the module
+	  will be called snd-omap-aic23.
+	  
+config SND_OMAP_TSC2101
+ 	tristate "OMAP TSC2101 alsa driver"
+ 	depends on ARCH_OMAP && SND
+ 	select SND_PCM
+         select SPI_TSC2101
+ 	help
+ 	  Say Y here if you have a OMAP platform board
+ 	  and want to use its TSC2101 audio chip. Driver has
+ 	  been tested with H2 and iPAQ h6300.
+ 
+ 	  To compile this driver as a module, choose M here: the module
+ 	  will be called snd-omap-tsc2101.
+
+config SND_SX1
+ 	tristate "Siemens SX1 Egold alsa driver"
+ 	depends on ARCH_OMAP && SND
+ 	select SND_PCM
+ 	help
+ 	  Say Y here if you have a OMAP310 based Siemens SX1.
+
+ 	  To compile this driver as a module, choose M here: the module
+ 	  will be called snd-omap-sx1.
+
+config SND_OMAP_TSC2102
+ 	tristate "OMAP TSC2102 alsa driver"
+ 	depends on ARCH_OMAP && SND
+ 	select SND_PCM
+	select SPI_TSC2102
+ 	help
+ 	  Say Y here if you have an OMAP platform board
+ 	  and want to use its TSC2102 audio chip.
 
+ 	  To compile this driver as a module, choose M here: the module
+ 	  will be called snd-omap-tsc2102.
+
+config SND_OMAP24XX_EAC
+	tristate "Audio driver for OMAP24xx EAC"
+	depends on SND
+	help
+	  Audio driver for Enhanced Audio Controller found in TI's OMAP24xx
+	  processors.
+
+	  Currently contains only low-level support functions for
+	  initializing EAC HW, creating ALSA sound card instance for it
+	  and registering mixer controls implemented by a codec driver.
+	  PCM stream is expected to be under DSP co-processor control.
+
+	  To compile this driver as a module, choose M here: the module
+	  will be called snd-omap24xx-eac.
+
+endif	# SND_ARM