--- kernel-2.6.27.orig/drivers/usb/musb/Kconfig
+++ kernel-2.6.27/drivers/usb/musb/Kconfig
@@ -11,7 +11,7 @@
 	depends on (USB || USB_GADGET) && HAVE_CLK
 	depends on !SUPERH
 	select TWL4030_USB if MACH_OMAP_3430SDP
-	tristate 'Inventra Highspeed Dual Role Controller (TI, ...)'
+	tristate 'Inventra Highspeed Dual Role Controller (TI, ADI, ...)'
 	help
 	  Say Y here if your system has a dual role high speed USB
 	  controller based on the Mentor Graphics silicon IP.  Then
@@ -22,6 +22,9 @@
 	  Texas Instruments parts using this IP include DaVinci 644x,
 	  OMAP 243x, OMAP 343x, and TUSB 6010.
 
+	  Analog Devices parts using this IP include Blackfin BF54x,
+	  BF525 and BF527.
+
 	  If you do not know what this is, please say N.
 
 	  To compile this driver as a module, choose M here; the
@@ -33,10 +36,8 @@
 	default y if ARCH_DAVINCI
 	default y if ARCH_OMAP2430
 	default y if ARCH_OMAP34XX
-	help
-	  Use a static <asm/arch/hdrc_cnf.h> file to describe how the
-	  controller is configured (endpoints, mechanisms, etc) on the
-	  current iteration of a given system-on-chip.
+	default y if (BF54x && !BF544)
+	default y if (BF52x && !BF522 && !BF523)
 
 comment "DaVinci 644x USB support"
 	depends on USB_MUSB_HDRC && ARCH_DAVINCI
@@ -47,6 +48,9 @@
 comment "OMAP 343x high speed USB support"
 	depends on USB_MUSB_HDRC && ARCH_OMAP34XX
 
+comment "Blackfin high speed USB Support"
+	depends on USB_MUSB_HDRC && (BF54x && !BF544) || (BF52x && !BF522 && !BF523)
+
 config USB_TUSB6010
 	boolean "TUSB 6010 support"
 	depends on USB_MUSB_HDRC && !USB_MUSB_SOC
@@ -146,7 +150,7 @@
 config USB_INVENTRA_DMA
 	bool
 	depends on USB_MUSB_HDRC && !MUSB_PIO_ONLY
-	default ARCH_OMAP2430 || ARCH_OMAP34XX
+	default ARCH_OMAP2430 || ARCH_OMAP34XX || BLACKFIN
 	help
 	  Enable DMA transfers using Mentor's engine.
 
@@ -174,3 +178,11 @@
 	  This enables musb debugging. To set the logging level use the debug
 	  module parameter. Starting at level 3, per-transfer (urb, usb_request,
 	  packet, or dma transfer) tracing may kick in.
+
+config MUSB_PROC_FS
+	depends on USB_MUSB_HDRC && PROC_FS
+	bool "Enabled old musb procfs interface"
+	default n
+	help
+	  This enables the old musb procfs entry. Ideally this would move to a userland application
+	  talking to musb via usbfs and issueing the correct control messages.